Friday, 26 March 2010

Tea strainer

From my sketches I modeled one of my tea strainer designs. A cone to sit inside my cylinder. This came with a few obvious problems, the tea would not have space to brew, it sat awkwardly in the vessel and on the board and while sitting on the board after brewing it would make quite a mess.
So I looked in to another design from my sketch book. A cylinder to go inside my water vessel. This design would stand on the board and with the holes not reaching the bottom of the filter this should minimize mess.
Drawings to follow when I get a chance to scan my sketch book.

No comments:

Post a Comment